Technical Document
Specifications
Taper Type
Linear
Number of Pots per Package
2
Memory Type
Volatile
Resistance Value
10kΩ
Number of Positions
256
Control Interface
Serial-2 Wire
Power Supply Type
Single
Minimum Operating Temperature
-40 °C
Maximum Operating Temperature
+85 °C
Pin Count
16
Mounting Type
Through Hole
Height
4.45mm
Width
7.87mm
Typical Single Supply Voltage
3 V, 5 V
Length
19.43mm
Package Type
PDIP
Brand
Maxim IntegratedDimensions
19.43 x 7.87 x 4.45mm
Product details
Siemens Milltronics Motion Sensing
Siemens motion sensing controller and sensor combinations are used to detect changes in operation, such as motion an speed that could lead to costly malfunctions and failure. The MFA 4p controller on detection of a problem can send a signal via contacts to shut down machinery to prevent further damage or losses. Single set-point operation makes these units suitable for a variety of industries including, water and waste water. Requires a motion sensor 8044102 and sensor controller 8044086 for operation
Probe can be mounted up to 100mm from target
Selectable over-speed or under-speed detection
Start-up time delay
Temperature rating: -40°C to +60°C
IP67 rated (probe)
NEMA 4X, polycarbonate enclosure (alarm controller)
Aluminium Body (probe)
Siemens Flow / Motion Sensing
Stock information temporarily unavailable.
Please check again later.
P.O.A.
25
P.O.A.
25
Technical Document
Specifications
Taper Type
Linear
Number of Pots per Package
2
Memory Type
Volatile
Resistance Value
10kΩ
Number of Positions
256
Control Interface
Serial-2 Wire
Power Supply Type
Single
Minimum Operating Temperature
-40 °C
Maximum Operating Temperature
+85 °C
Pin Count
16
Mounting Type
Through Hole
Height
4.45mm
Width
7.87mm
Typical Single Supply Voltage
3 V, 5 V
Length
19.43mm
Package Type
PDIP
Brand
Maxim IntegratedDimensions
19.43 x 7.87 x 4.45mm
Product details
Siemens Milltronics Motion Sensing
Siemens motion sensing controller and sensor combinations are used to detect changes in operation, such as motion an speed that could lead to costly malfunctions and failure. The MFA 4p controller on detection of a problem can send a signal via contacts to shut down machinery to prevent further damage or losses. Single set-point operation makes these units suitable for a variety of industries including, water and waste water. Requires a motion sensor 8044102 and sensor controller 8044086 for operation
Probe can be mounted up to 100mm from target
Selectable over-speed or under-speed detection
Start-up time delay
Temperature rating: -40°C to +60°C
IP67 rated (probe)
NEMA 4X, polycarbonate enclosure (alarm controller)
Aluminium Body (probe)